While filming the other day with some of my colleagues for a short project we’re producing I noticed that the cameraman was having to balance the DSLR Camera rig with one hand while trying to press the record button on the back of the camera.
I had a little research on the internet and searched for how the pros do it with their camera rigs. It became apparent that unless you paid a ton of money for bespoke remote triggers for the model camera and rig you owned, it was something that most people lived without.
This can’t be right, surely!? After a bit more research I found this soon-to-be-released image of the BlackMagic Design Camera Cage with integrated wood handles and record-button:
It looks lovely and everything, but it can’t be complicated to build surely… It’s just a single button. SO! To the batcave!
Note! This is going to be THE EASIEST DIY project I’ve ever done. Anyone can do it and requires no knowledge of electronics at all.
Looking into MagicLantern (http://magiclantern.fm) there is an option to start recording by pressing the shutter-button half way. All I needed to do is create a remote button that does the same thing.
You’ll need the following components to complete the project: (click titles for links!)
- Drill a hole into the front of the plastic box and screw the button in the hole.
- Drill a second, smaller, hole into the back for the wire to come out.
- Drill a third hole on the top of the box for the rapid stand adapter to fit through.
- Screw and mount the Rapid Stand Adapter into the top of the plastic box.
- Screw and mount the push button into the front of the plastic box.
- Cut the ends off the stereo headphone wire (there should actually be two wires – hence stereo) and solder one wire to one side of the push button and the other wire to the other side.
- Thread the wire through the back of the box.
- Solder the other ends of the wires to the jack plug. NOTE : The only tricky bit is to make sure you solder the wire to the ground outer part of the plug and more importantly the inner ring of the plug, NOT the connection to the tip of the plug. The jack has three sections and the tip will activate the shutter (full press), the middle connector will activate the focus (half press – or video mode for us!) and the ground bottom part. [see below]
Once everything is soldered and connected you should have a loop with the button on one end and the jack plug on the other. Simple, right?
Screw the box tight and make sure everything is screwed in and soldered properly.
Now time to test! Plug the jack into your remote trigger port on the Canon DSLR and make sure that MagicLantern is set to start recording on half-shutter.
Voila! Good to go. One remote DSLR record button that fits onto your 15mm rig. For any questions fire them over on twitter(@lonetraceur) and I’ll try to help. This shouldn’t be hard though!
See my rig below.